Silhouette Blade Cutting Through Vinyl Backing

If this happened the blade is cutting too deep.

Silhouette blade cutting through vinyl backing. Can the triangle be removed completely without any places sticking. The end cap unscrews while it s cutting it won t automatically set itself to the cut settings in the send menu etc. For me this is the bane of using vinyl. If you ve just replaced your blade and are having this problem you probably have the wrong blade.

I sure hope it works. Silhouette finally has more autoblades available and is sending me a new one. Once the cut is finished use the unload button on your machine to unload your vinyl. How to stop cutting through vinyl backing.

Place the vinyl onto the silhouette cutting mat with the backing paper side down onto the mat making sure the vinyl is covering the same area where the design is placed on the virtual mat in silhouette studio. This video shows how i resolved a silhouette vinyl cutting issue. To cut properly the blade must be pushed all the way down with no visible gap between the tool holder and the blade. When cutting adhesive vinyl or heat transfer vinyl a kiss cut is used to cut the vinyl but leave the carrier sheet or backing intact.

Did it cut cleanly through the vinyl. One of the most common issues from silhouette cameo beginners is that their cameo 3 autoblade is cutting through the vinyl or other material and the backing. Trying out new vinyl or felt a blunt blade or any other number of reasons. Just remove the blade from the carriage put it blade side down into the indention and turn until the blade is on the setting you want.

Blade ratchet to change blade setting on each machine made in the last 3 years or so there is a round indentation on the machine in the lower left hand side. Once the vinyl is removed look at your test cut. My friend and fellow instructor elly from silhouette secrets has diagnosed this issue so often on facebook that she keeps a photo of a properly installed blade on hand to post whenever someone is having cutting issues. The same goes for the portrait 2 autoblade.

If your cricut cuts through the backing there are usually one of two possible issues. If your silhouette cutting mat is brand new you may want to de stick the cutting mat somewhat by blotting it with a clean t shirt. Did the machine cut all the way through to the back. 1 blade is not properly inserted and or locked down.

I can use an older style ratchet blade in the adapter and it will cut fine.