Removing Carpet Nail Strips From Concrete

If you re removing your old carpet and planning to install new carpet in its place you don t have to remove.

Removing carpet nail strips from concrete. If you decide to remove the carpet you must also pry up the tack strips which are held in place with nails. Carpet tack strips are wooden boards installed around the perimeter of a floor to hold carpet in place. Pry up the metal nosing and remove it if present. The strips of metal nails under your carpet and carpet padding are called tack strips.

Grab the cut end of carpet and pull it from the stairs using gloved hands. I did remove tack strips from a terazzo concrete floor before refinishing the floor with an acid wash. Here s where things take a turn from the expected aka carpet installed over wood subfloors. Carpet tack strips are pieces of wood with small sharp nails sticking out of them that grip a carpet and hold it in place.

If you are pulling up carpet from stairs. Removing carpet from a concrete slab involves also removing the approximately 10 million nails driven straight into the concrete around the perimeter of the room. Its not that hard with these tips from clay king from aaa flood drying with 28. The strips are nailed to the subfloor and while removing them is labor.

If not cut the carpet near the top of the top stair riser. You can take the woode out from around the nails and then. Begin at the top of the stairs. When you remove the tack strip it tends to leave a small hole where the concrete has been broken from the nails.

You must not pull out the nails. Carpet tack strips can usually remain in place but look for rust rot or other damage. Most carpet is secured along the outer edge with a tack strip which are typically nailed into the concrete.